7.9E Spurious emissions for UE category 0
36.521-13GPPEvolved Universal Terrestrial Radio Access (E-UTRA)Part 1: Conformance testingRadio transmission and receptionRelease 17TSUser Equipment (UE) conformance specification
The spurious emissions power is the power of emissions generated or amplified in a receiver that appear at the UE antenna connector.
7.9E.1 Test Purpose
Same test purpose as in clause 7.9.1.
7.9E.2 Test Applicability
This test applies to all types of E-UTRA UE release 12 and forward of UE category 0.
7.9E.3 Minimum Conformance Requirements
Same minimum conformance requirements as in clause 7.9.3.
7.9E.4 Test Description
7.9E.4.1 Initial Conditions
Same initial conditions as in clause 7.9.4.1 with the following exceptions:
– Instead of Table 7.9.4.1-1 🡪 use Table 7.9E.4.1-1.
– Connect the SS to the UE antenna connectors as shown in TS 36.508[7] Annex A Figure A.8 using only main UE Tx/Rx antenna.
Table 7.9E.4.1-1: Test Configuration Table
|
Initial Conditions |
||||||
|
Test Environment as specified in TS 36.508[7] subclause 4.1 |
NC |
|||||
|
Test Frequencies as specified in TS36.508 [7] subclause 4.3.1 |
Low range, Mid range, High range |
|||||
|
Test Channel Bandwidths as specified in TS 36.508 [7] subclause 4.3.1 |
Highest |
|||||
|
Test Parameters for Channel Bandwidths |
||||||
|
Downlink Configuration |
Uplink Configuration |
|||||
|
Ch BW |
Mod’n |
RB allocation |
Mod’n |
RB allocation |
||
|
FDD and HD-FDD |
TDD |
FDD and HD-FDD |
TDD |
|||
|
1.4MHz |
QPSK |
0 |
0 |
QPSK |
0 |
0 |
|
3MHz |
QPSK |
0 |
0 |
QPSK |
0 |
0 |
|
5MHz |
QPSK |
0 |
0 |
QPSK |
0 |
0 |
|
10MHz |
QPSK |
0 |
0 |
QPSK |
0 |
0 |
|
15MHz |
QPSK |
0 |
0 |
QPSK |
0 |
0 |
|
20MHz |
QPSK |
0 |
0 |
QPSK |
0 |
0 |
|
Note 1: Test Channel Bandwidths are checked separately for each E-UTRA band. The applicable channel bandwidths are specified in Table 7.3E.3-3. |
||||||
7.9E.4.2 Test Procedure
Same test procedure as in clause 7.9.4.2
7.9E.4.3 Message Contents
Message contents are according to TS 36.508 [7] subclause 4.6.
7.9E.5 Test Requirement
The measured spurious emissions derived in step 1), shall not exceed the maximum level specified in Table 7.9E.5-1.
Table 7.9E.5-1: General receiver spurious emission requirements
|
Frequency Band |
Measurement Bandwidth |
Maximum level |
Note |
|
30MHz ≤ f < 1GHz |
100 kHz |
-57 dBm |
|
|
1GHz ≤ f ≤ 12.75 GHz |
1 MHz |
-47 dBm |
|
|
12.75 GHz ≤ f ≤ 5th harmonic of the upper frequency edge of the DL operating band in GHz |
1 MHz |
-47 dBm |
Note 1 |
|
Note 1: Applies only for Band 22, Band 42 and Band 43. Note 2: Unused PDCCH resources are padded with resource element groups with power level given by PDCCH_RA/RB as defined in Annex C.3.1. |
|||