6.7EB Transmit intermodulation for UE category 1bis
36.521-13GPPEvolved Universal Terrestrial Radio Access (E-UTRA)Part 1: Conformance testingRadio transmission and receptionRelease 17TSUser Equipment (UE) conformance specification
6.7EB.1 Test purpose
Same test purpose as in clause 6.7.1.
6.7EB.2 Test applicability
This test case applies to all types of E-UTRA UE release 13 and forward of UE category 1bis.
6.7EB.3 Minimum conformance requirements
Same minimum conformance requirements as in clause 6.7.3.
6.7EB.4 Test description
6.7EB.4.1 Initial conditions
Same initial conditions as in clause 6.7.4.1 with following exception.
– Connect SS to the UE antenna connectors as shown in TS 36.508[7] Annex A Figure A.3 using only main UE Tx/Rx antenna.
6.7EB.4.2 Test procedure
Same test procedure as in clause 6.7.4.2
6.7EB.4.3 Message contents
Message contents same as 6.7.4.3.
6.7EB.5 Test requirement
The ratio derived in step 5 and 7, shall not exceed the described value in table 6.7EB.5-1
Table 6.7EB.5-1: Transmit Intermodulation
|
BWChannel (UL) |
5MHz |
10MHz |
15MHz |
20MHz |
||||
|
Interference Signal Frequency Offset |
5MHz |
10MHz |
10MHz |
20MHz |
15MHz |
30MHz |
20MHz |
40MHz (Note 1) |
|
Interference CW Signal Level |
-40dBc |
|||||||
|
Intermodulation Product |
-29dBc |
-35dBc |
-29dBc |
-35dBc |
-29dBc |
-35dBc |
-29dBc |
-35dBc |
|
Measurement bandwidth |
4.5MHz |
4.5MHz |
9.0MHz |
9.0MHz |
13.5MHz |
13.5MHz |
18MHz |
18MHz |
|
Note 1: For Band 20, only applicable for interference signal frequency above the UL carrier frequency. |
||||||||