14.2.4 Reference sensitivity – FACCH/H
3GPP51.010-1Mobile Station (MS) conformance specificationPart 1: Conformance specificationTS
14.2.4.1 Definition
The reference sensitivity for control channels is the signal level at the MS receiver input at which a certain FER must be achieved.
14.2.4.2 Conformance requirement.
At reference sensitivity level, the FACCH/H FER shall meet the reference sensitivity performance of table 1 in 3GPP TS 05.05 subclause 6.2.
14.2.4.3 Test purpose.
To verify that the MS does not exceed the conformance requirement under TUhigh propagation condition with an allowance for the statistical significance of the test.
14.2.4.4 Method of test
14.2.4.4.1 Initial conditions
A call is set up according to the generic call set up procedure on TCH/HS, TCH/H4.8, TCH/H2.4 or any TCH/AHS, whichever supported by the MS, with an ARFCN in the Mid ARFCN range, power control level set to maximum power.
The SS transmits Standard Test Signal C1 on the traffic channel.
14.2.4.4.2 Procedure
a) The fading function is set to TUhigh.
b) The SS sets the amplitude of the wanted signal to reference sensitivity level ( ).
c) The SS sends a Layer 3 message which does not require a Layer 3 response from the MS. Due to the low signal level the MS may not be able to acknowledge the Layer 2 frame with an RR frame and the SS will repeat the Layer 2 frame. Each repeated L2 frame will be counted and will indicate a frame erasure event.
d) The SS determines the frame erasure events during at least the minimum number of samples of FACCH/H frames.
NOTE: These frames will not be consecutive but it is expected that the statistical significance of the tests will not be unduly degraded.
14.2.4.5 Test requirements
The error rates measured shall not exceed the test limit error rate values given in table 14-10.
Table 14-10: Limits for FACCH/H sensitivity
GSM 400, GSM 700, T-GSM 810, GSM 850 and GSM 900 |
DCS 1 800 and PCS 1 900 |
|||||
Channels |
Type of measurements |
Propagation |
Test limit error rate % |
Minimum No of samples |
Test limit error rate % |
Minimum No of samples |
FACCH/H |
FER |
TUhigh |
7,728 |
8,064 |