8.2 Demodulation in static propagation conditions
25.1013GPPRelease 17TSUser Equipment (UE) radio transmission and reception (FDD)
8.2.1 (void)
8.2.2 (void)
8.2.3 Demodulation of Dedicated Channel (DCH)
The receive characteristic of the Dedicated Channel (DCH) in the static environment is determined by the Block Error Ratio (BLER). BLER is specified for each individual data rate of the DCH. DCH is mapped into the Dedicated Physical Channel (DPCH).
8.2.3.1 Minimum requirement
For the parameters specified in Table 8.5 the average downlink power ratio shall be below the specified value for the BLER shown in Table 8.6. These requirements are applicable for TFCS size 16.
Table 8.5: DCH parameters in static propagation conditions
Parameter |
Unit |
Test 1 |
Test 2 |
Test 3 |
Test 4 |
||||||
Phase reference |
P-CPICH |
||||||||||
|
dB |
-1 |
|||||||||
|
dBm/3.84 MHz |
-60 |
|||||||||
Information Data Rate |
kbps |
12.2 |
64 |
144 |
384 |
Table 8.6: DCH requirements in static propagation conditions
Test Number |
|
BLER |
1 |
-16.6 dB |
10-2 |
2 |
-13.1 dB |
10-1 |
-12.8 dB |
10-2 |
|
3 |
-9.9 dB |
10-1 |
-9.8 dB |
10-2 |
|
4 |
-5.6 dB |
10-1 |
-5.5 dB |
10-2 |
8.2.4 Demodulation of Dedicated Channel (DCH) when DL_DCH_FET_Config [10] is configured by higher layers
The receive characteristic of the Dedicated Channel (DCH) in the static environment is determined by the Block Error Ratio (BLER). BLER is specified for each individual data rate of the DCH. DCH is mapped into the Dedicated Physical Channel (DPCH).
8.2.4.1 Minimum requirement
For the parameters specified in Table 8.6A the average downlink power ratio shall be below the specified value for the BLER shown in Table 8.6B. These requirements are applicable for TFCS size 16.
Table 8.6A: DCH parameters in static propagation conditions
Parameter |
Unit |
Test 1 |
Test 2 |
Test 3 |
Test 4 |
||||||
Phase reference |
P-CPICH |
||||||||||
|
dB |
-1 |
|||||||||
|
dBm/3.84 MHz |
-60 |
|||||||||
Information Data Rate |
kbps |
12.2 |
12.2 |
0 |
0 |
||||||
DCCH Presence |
– |
Yes |
No |
Yes |
No |
||||||
DL_DCH_FET_Config |
– |
0 (Note 1) |
|||||||||
Note 1: UL is in 10ms transmission mode |
Table 8.6B: DCH requirements in static propagation conditions
Test Number |
|
BLER |
1 |
-17.6 dB |
10-2 |
2 |
-15.5 dB |
10-2 |
3 |
-19.3 dB |
10-2 |
4 |
-17.2 dB |
10-2 |