7.7 Spurious response
25.1013GPPRelease 17TSUser Equipment (UE) radio transmission and reception (FDD)
7.7.1 Minimum requirement
Spurious response is a measure of the receiver’s ability to receive a wanted signal on its assigned channel frequency without exceeding a given degradation due to the presence of an unwanted CW interfering signal at any other frequency at which a response is obtained i.e. for which the out of band blocking limit as specified in subclause 7.6.2 is not met.
The BER shall not exceed 0.001 for the parameters specified in Table 7.8.
Table 7.8: Spurious Response
|
Parameter |
Unit |
Level |
|
DPCH_Ec |
dBm/3.84 MHz |
<REFSENS> +3 dB |
|
Îor |
dBm/3.84 MHz |
<REFÎor> +3 dB |
|
Iblocking (CW) |
dBm |
-44 |
|
Fuw |
MHz |
Spurious response frequencies |
|
UE transmitted mean power |
dBm |
20 (for Power class 3 and 3bis) 18 (for Power class 4) NOTE 2 |
|
NOTE 1: <REFSENS> and <REFÎor> refer to the DPCH_Ec<REFSENS> and the DPCH<REFÎor> as specified in Table 7.2. NOTE 2 :The UE transmitted mean power shall be reduced by 0.5dB for a UE operating in band XXII. |
||
7.7.2 Additional requirement for DC-HSDPA, DB-DC-HSDPA, single band/dual band 4C-HSDPA and single band 8C-HSDPA and single band NC-4C-HSDPA
Spurious response is a measure of the receiver’s ability to receive a wanted signal on its assigned channel frequency without exceeding a given degradation due to the presence of an unwanted CW interfering signal at any other frequency at which a response is obtained i.e. for which the out of band blocking limit as specified in subclause 7.6.2A, 7.6.2B, 7.6.2C, 7.6.2D or 7.6.2E or 7.6.2F is not met.
The BLER measured on each individual cell shall not exceed 0.1 for the parameters specified in Table 7.8A. The requirement is not applicable for dual uplink operation.
Table 7.8A: Spurious Response
|
Parameter |
Unit |
Level |
|
HS-PDSCH_Ec |
dBm/3.84 MHz |
<REFSENS> +3 dB |
|
Îor |
dBm/3.84 MHz |
<REFÎor> +3 dB |
|
Iblocking (CW) |
dBm |
-44 |
|
Fuw |
MHz |
Spurious response frequencies |
|
UE transmitted mean power |
dBm |
20 (for Power class 3 and 3bis) 18 (for Power class 4) N OTE 2 |
|
NOTE 1: <REFSENS> and <REFÎor> refer to the HS-PDSCH_Ec<REFSENS> and the HS-PDSCH<REFÎor> as specified in Table 7.2A for DC-HSDPA, Table 7.2B for DB-DC-HSDPA, Table 7.2C for single band 4C-HSDPA, Table 7.2D for dual band 4C-HSDPA and Table 7.2E for single band 8C-HSDPA and 7.2F for single band NC-4C-HSDPA. NOTE 2: The UE transmitted mean power shall be reduced by 0.5dB for a UE operating in band XXII. |
||