7.9 Spurious emissions

25.1013GPPRelease 17TSUser Equipment (UE) radio transmission and reception (FDD)

The spurious emissions power is the power of emissions generated or amplified in a receiver that appear at the UE antenna connector. The spurious emission is verified per antenna connector with the other(s) terminated.

7.9.1 Minimum requirement

The power of any narrow band CW spurious emission shall not exceed the maximum level specified in Table 7.10, Table 7.11 and Table 6.13.

Table 7.10: General receiver spurious emission requirements

Frequency Band

Measurement

Bandwidth

Maximum level

Note

30MHz ≤ f < 1GHz

100 kHz

-57 dBm

1GHz ≤ f ≤ 12.75 GHz

1 MHz

-47 dBm

12.75GHz ≤ f ≤ 5th harmonic of the upper frequency edge of the DL operating band in GHz

1 MHz

-47 dBm

Note 1

NOTE 1: Applies only for Band XXII.

Table 7.11: Additional receiver spurious emission requirements

Band

Frequency Band

MeasurementBandwidth

Maximum level

Note

I

1920 MHz ≤ f ≤ 1980 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

II

1850 MHz ≤ f ≤ 1915 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

III

1710 MHz ≤ f ≤ 1785 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

IV

1710 MHz  f < 1755 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

V

824 MHz  f ≤ 849 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

VI

815 MHz  f ≤ 830 MHz

3.84 MHz

-60 dBm

830 MHz ≤ f ≤ 840 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

840 MHz ≤ f ≤ 845 MHz

3.84 MHz

-60 dBm

860 MHz ≤ f ≤ 875 MHz

3.84 MHz

-60 dBm

VII

2500 MHz ≤ f ≤ 2570 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

VIII

880 MHz f 915 MHz

3.84 MHz

-60 dBm

UE in URA_PCH, Cell_PCH and idle state

IX

1749.9 MHz ≤ f ≤ 1784.9 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

X

1710 MHz  f < 1770 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XI

1427.9 MHz ≤ f ≤ 1447.9 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XII

699 MHz ≤ f 716 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XIII

746 MHz ≤ f ≤ 756 MHz

3.84 MHz

-60 dBm

UE receive band

776 MHz ≤ f ≤ 788 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XIV

788 MHz ≤ f ≤ 798 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XIX

815 MHz  f ≤ 830 MHz

3.84 MHz

-60 dBm

830 MHz ≤ f ≤ 845 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

860 MHz ≤ f ≤ 875 MHz

3.84 MHz

-60 dBm

XX

832 MHz ≤ f ≤ 862 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XXI

1447.9 MHz ≤ f ≤ 1462.9 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XXII

3410 MHz  f  3490 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XXV

1850 MHz ≤ f ≤ 1915 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

XXVI

814 MHz ≤ f ≤ 849 MHz

3.84 MHz

-60 dBm

UE transmit band in URA_PCH, Cell_PCH and idle state

Note * The receiver additional spurious emission measurements are made on frequencies which are integer multiples of 200 kHz. As exceptions, up to five measurements with a level up to the applicable requirements defined in Table 7.10 are permitted for each UARFCN used in the measurement. This note applies also to receiver additional spurious emission measurements according to Table 6.11.

7.9.1A Minimum requirement

For DB-DC-HSDPA and Dual band 4C-HSDPA configurations including an operating band without UL Band, the power of any narrow band CW spurious emission shall not exceed the maximum level specified in Table 7.12.

Table 7.12: General receiver spurious emission requirements

Frequency Band

Measurement

Bandwidth

Maximum level

Note

30MHz ≤ f < 1GHz

100 kHz

-57 dBm

1GHz ≤ f ≤ 12.75 GHz

1 MHz

-47 dBm

NOTE 1: The requirements apply when the UE is configured for DL multicarrier operation but is not transmitting.