7.7A Spurious response for CA
38.101-13GPPNRPart 1: Range 1 StandaloneRelease 17TSUser Equipment (UE) radio transmission and reception
7.7A.1 Spurious response for Intra-band contiguous CA
Table 7.7A-1: Spurious response parameters for intra-band contiguous CA
RX parameter |
Units |
NR CA bandwidth class |
|||
B |
C |
D |
|||
Power in transmission bandwidth configuration |
dBm |
REFSENS + CA bandwidth class specific value below |
|||
dB |
9 |
9 |
9 |
||
NOTE 1: The transmitter shall be set to 4 dB below PCMAX_L,f,c at the minimum UL configuration specified in Table 7.3.2-3 with PCMAX_L,f,c defined in clause 6.2.4. |
Table 7.7A-2: Spurious response for CA
Parameter |
Unit |
Level |
PInterferer (CW) |
dBm |
-44 |
FInterferer |
MHz |
Spurious response frequencies |
Table 7.7A-3: Void
Table 7.7A-4: void
7.7A.2 Spurious response for Intra-band non-contiguous CA
For intra-band non-contiguous carrier aggregation with one uplink carrier and two or more downlink sub-blocks, the spurious response requirements are defined with the uplink configuration in accordance with Table 7.3A.2.2-1. For this uplink configuration, the UE shall meet the requirements for each sub-block as specified in clauses 7.7 and 7.7A.1 for one component carrier and two component carriers per sub-block, respectively. The requirements apply with all downlink carriers active.
The throughput of each carrier shall be ≥ 95 % of the maximum throughput of the reference measurement channels as specified in Annexes A.2.2, A.3.2, and A.3.3 (with one sided dynamic OCNG Pattern OP.1 FDD/TDD for the DL-signal as described in Annex A.5.1.1/A.5.2.1).
7.7A.3 Spurious response for Inter-band CA
For inter-band carrier aggregation with one component carrier per operating band and the uplink assigned to one NR band, the spurious response are defined with the uplink active on the band(s) other than the band whose downlink is being tested. The UE shall meet the requirements specified in clause 7.7 for each component carrier while all downlink carriers are active.
For the UE which supports inter-band CA configuration in Table 7.3A.3.2.1-1, Pinterferer power defined in Table 7.7-2 is increased by the amount given by ΔRIB,c in Table 7.3A.3.2.1-1.
The throughput of each carrier shall be ≥ 95 % of the maximum throughput of the reference measurement channels as specified in Annexes A.2.2, A.3.2, and A.3.3 (with one sided dynamic OCNG Pattern OP.1 FDD/TDD for the DL-signal as described in Annex A.5.1.1/A.5.2.1).