7.6C Blocking characteristics for SUL
38.101-13GPPNRPart 1: Range 1 StandaloneRelease 17TSUser Equipment (UE) radio transmission and reception
7.6C.1 General
7.6C.2 In-band blocking for SUL
For SUL operation, the in-band blocking requirement for downlink bands specified in clause 7.6.2 shall be met.
For SUL operation with downlink CA, the in-band blocking requirement for downlink bands specified in clause 7.6A.2 shall be met.
7.6C.3 Out-of-band blocking for SUL
For SUL operation, the out-of-band blocking requirement for downlink bands specified in clause 7.6.3 shall be met. For SUL operation with downlink CA, the out-of-band blocking requirement for downlink bands specified in clause 7.6A.3 shall be met. For operation band combination listed in Table 7.6C.3-1, exceptions to the requirement specified in Table 7.6C.3-2 are allowed when the second order intermodulation product of the SUL carrier and the CW interfering signal fully or partially overlaps with the DL carrier.
Table 7.6C.3-1: SUL operating band combination with exceptions allowed
|
NR Band combination for SUL |
|
SUL_n78-n81 |
|
SUL_n78-n82 |
|
SUL_n78-n83 |
|
SUL_n79-n81 |
|
SUL_n79-n83 |
Table 7.6C.3-2: Requirement for out-of-band blocking exceptions
|
Parameter |
Unit |
Level |
|
PInterferer (CW) |
dBm |
-441 |
|
NOTE 1: The requirement applies when, where and are the channel bandwidths configured for SUL and DL (victim) bands in MHz, respectively. |
||
For all interferer frequency ranges specified in clause 7.6.3 a maximum of
exceptions are allowed for spurious response frequencies in each assigned frequency channel when measured using a step size of 
MHz with NRB the number of resource blocks in the downlink transmission bandwidth configuration, BWChannel the bandwidth of the frequency channel in MHz and n = 1, 2, 3 for SCS = 15, 30, 60 kHz, respectively. For these exceptions, the requirements in clause 7.7 apply.
7.6C.4 Narrow band blocking for SUL
Narrow band blocking is not specified for SUL band combination.