8.3 Capabilities for Support of Event Triggering and Reporting Criteria in CELL_DCH state
25.1333GPPRelease 17Requirements for support of radio resource management (FDD)TS
8.3.1 Introduction
This section contains requirements on UE capabilities for support of event triggering and reporting criteria. As long as the measurement configuration does not exceed the requirements stated in section 8.3.2, the UE shall meet the performance requirements defined in section 9.
The UE can be requested to make measurements under different Measurement Identities [16]. Each Measurement Identity corresponds to either event based reporting, periodic reporting or no reporting. In case of event based reporting, each Measurement Identity is associated with one or more events, each identified with an Event Identity. In case of periodic reporting, a Measurement Identity is associated with one periodic reporting criterion. In case of no reporting, a Measurement Identity is associated with one no reporting criterion.
The purpose of this section is to set some limits on the number of different event, periodic and no reporting criteria the UE may be requested to track in parallel.
8.3.2 Requirements
In this section a reporting criterion corresponds to either one event (in the case of event based reporting), or one periodic reporting criterion (in case of periodic reporting), or one no reporting criterion (in case of no reporting). For event based reporting, each instance of event, with the same or different Event Identities, is counted as separate reporting criterion in Table 8.10.
The UE shall be able to support in parallel per category up to Ecat reporting criteria according to Table 8.10. If the UE is configured with a single uplink carrier frequency, for the measurement categories: Intra-frequency, Inter frequency, Inter frequency (virtual active set), and Inter-RAT the UE need not support more than 42 reporting criteria in total. If the UE is configured with dual uplink carrier frequencies, for the measurement categories: Intra-frequency, Inter frequency, Inter frequency (virtual active set), and Inter-RAT the UE need not support more than 55 reporting criteria in total. For the measurement categories: Traffic volume and Quality measurements the UE need not support more than 16 reporting criteria in total.
Table 8.10: Requirements for reporting criteria per measurement category
|
Measurement category |
Ecat |
Note |
|
Intra-frequency |
16 |
|
|
Inter-frequency |
16 |
|
|
Inter-frequency, virtual active set |
4 |
|
|
Inter-RAT GERAN |
4 |
Only applicable for UE with this capability |
|
Inter-RAT E-UTRAN |
48 |
Only applicable for UE with this capability |
|
UE internal measurements |
8 |
|
|
Traffic volume measurements |
2 + (2 per Transport Channel) |
|
|
Quality measurements |
2 per Transport Channel |
|
|
UP measurements |
2 |
Only applicable for UE with this capability. |
|
UE Rx-Tx time difference measurement |
1 |
|
|
Note: When the UE is configured with dual uplink carrier frequencies, Ecat for Intra-frequency is applied per intra-frequency. |
||