C.3 Connection
38.521-23GPPNRPart 2: Range 2 StandaloneRadio transmission and receptionRelease 17TSUser Equipment (UE) conformance specification
C.3.0 Measurement of Transmitter Characteristics
Unless otherwise stated, Table C.3.0-1 is applicable for measurements on the Transmitter Characteristics (clause 6).
Table C.3.0-1: Downlink Physical Channels transmitted during a connection (TDD)
|
Parameter |
Unit |
Value |
|
SSS transmit power |
W |
Test specific |
|
EPRE ratio of PSS to SSS |
dB |
0 |
|
EPRE ratio of PBCH to SSS |
dB |
0 |
|
EPRE ratio of PBCH to PBCH DMRS |
dB |
0 |
|
EPRE ratio of PDCCH to SSS |
dB |
0 |
|
EPRE ratio of PDCCH to PDCCH DMRS |
dB |
0 |
|
EPRE ratio of PDSCH to SSS |
dB |
0 |
|
EPRE ratio of PDSCH to PDSCH DMRS (Note 1) |
dB |
-3 |
|
EPRE ratio of CSI-RS to SSS |
dB |
0 |
|
EPRE ratio of PTRS to PDSCH |
dB |
Test specific |
|
EPRE ratio of OCNG DMRS to SSS |
dB |
0 |
|
EPRE ratio of OCNG to OCNG DMRS (Note 1) |
dB |
0 |
|
Note 1: No boosting is applied to any of the channels except PDSCH DMRS. For PDSCH DMRS, 3 dB power boosting is applied assuming DMRS Type 1 configuration when DMRS and PDSCH are TDM’ed and only half of the DMRS REs are occupied. Note 2: Number of DMRS CDM groups without data for PDSCH DMRS configuration for OCNG is set to 1. |
||
C.3.1 Measurement of Receiver Characteristics
Unless otherwise stated, Table C.3.1-1 is applicable for measurements on the Receiver Characteristics (clause 7). For Adjacent channel selectivity testing, Table C.3.1-2 is applied.
Table C.3.1-1: Downlink Physical Channels transmitted during a connection (TDD)
|
Parameter |
Unit |
Value |
|
SSS transmit power |
W |
Test specific |
|
EPRE ratio of PSS to SSS |
dB |
0 |
|
EPRE ratio of PBCH to SSS |
dB |
0 |
|
EPRE ratio of PBCH to PBCH DMRS |
dB |
0 |
|
EPRE ratio of PDCCH to SSS |
dB |
0 |
|
EPRE ratio of PDCCH to PDCCH DMRS |
dB |
0 |
|
EPRE ratio of PDSCH to SSS |
dB |
0 |
|
EPRE ratio of PDSCH to PDSCH DMRS (Note 1) |
dB |
-3 |
|
EPRE ratio of CSI-RS to SSS |
dB |
0 |
|
EPRE ratio of PTRS to PDSCH |
dB |
Test specific |
|
EPRE ratio of OCNG DMRS to SSS |
dB |
0 |
|
EPRE ratio of OCNG to OCNG DMRS (Note 1) |
dB |
0 |
|
Note 1: No boosting is applied to any of the channels except PDSCH DMRS. For PDSCH DMRS, 3 dB power boosting is applied assuming DMRS Type 1 configuration when DMRS and PDSCH are TDM’ed and only half of the DMRS REs are occupied. Note 2: Number of DMRS CDM groups without data for PDSCH DMRS configuration for OCNG is set to 1. |
||
Table C.3.1-2: PDCCH Aggregation Level for ACS testing
|
Parameter |
Unit |
Value |
Comment |
|
Aggregation level |
CCE |
4 |
CBW=50MHz when SCS=120kHz |
|
8 |
CBW=50MHz when SCS=60kHz CBW=100MHz when SCS=120kHz |
||
|
16 |
CBW>100 MHz when SCS=60kHz CBW>100 MHz when SCS=120kHz |
Annex D (normative):
Characteristics of the interfering signal