7.9 Spurious emissions

36.1013GPPEvolved Universal Terrestrial Radio Access (E-UTRA)Release 18TSUser Equipment (UE) radio transmission and reception

The spurious emissions power is the power of emissions generated or amplified in a receiver that appear at the UE antenna connector.

7.9.1 Minimum requirements

The power of any narrow band CW spurious emission shall not exceed the maximum level specified in Table 7.9.1-1

Table 7.9.1-1: General receiver spurious emission requirements

Frequency band

Measurement

bandwidth

Maximum level

NOTE

30MHz ≤ f < 1GHz

100 kHz

-57 dBm

1GHz ≤ f ≤ 12.75 GHz

1 MHz

-47 dBm

12.75 GHz ≤ f ≤ 5th harmonic of the upper frequency edge of the DL operating band in GHz

1 MHz

-47 dBm

1

12.75 GHz – 26GHz

1 MHz

-47dBm

3

NOTE 1: Applies only for Band 22, Band 42, Band 43, Band 48 and Band 49

NOTE 2: Unused PDCCH resources are padded with resource element groups with power level given by PDCCH_RA/RB as defined in Annex C.3.1.

NOTE 3: Applies for Band 46 and Band 47

In addition, for a V2X UE operating in Region 1, the power of any spurious emission shall not exceed the levels specified in Table 7.9.1-2.

Table 7.9.1-2: Additional RX spurious emissions limits in Region 1

Frequency Range

Maximum Level

Measurement bandwidth

NOTE

5795 MHz ≤ f < 5815MHz

-65 dBm (EIRP)

1 MHz

NOTE: The EIRP requirement is converted to conducted requirement depend on the supported post antenna connector gain Gpost connector declared by the UE following the principle described in annex I. The additional Rx spurious emission limits, only apply when the network signaling value NS_33 or NS_34 is indicated.

7.9.1A Minimum requirements

For E-UTRA CA configurations including an operating band without uplink band (as noted in Table 5.5-1), the power of any narrow band CW spurious emission shall not exceed the maximum level specified in Table 7.9.1A-1.

Table 7.9.1A-1: General receiver spurious emission requirements

Frequency band

Measurement

bandwidth

Maximum level

NOTE

30MHz ≤ f < 1GHz

100 kHz

-57 dBm

1GHz ≤ f ≤ 12.75 GHz

1 MHz

-47 dBm

12.75 GHz ≤ f ≤ 26 GHz

1 MHz

-47 dBm

3

NOTE 1: Unused PDCCH resources are padded with resource element groups with power level given by PDCCH_RA/RB as defined in Annex C.3.1.

NOTE 2: The requirements apply when the UE is configured for carrier aggregation but is not transmitting.

NOTE 3: Applies only for Band 46