G.1 Transmitter measurements
25.1413GPPBase Station (BS) conformance testing (FDD)Release 17TS
Table G.1: Equipment accuracy for transmitter measurements
|
Test |
Equipment accuracy |
Range over which equipment accuracy applies |
|
6.2.1 Maximum Output Power |
Not critical |
Not critical |
|
6.2.2 CPICH Power accuracy |
Not critical |
Not critical |
|
6.3 Frequency error |
± 10 Hz + timebase = [12] Hz |
Measurements in the range ±500 Hz. |
|
6.4.2 Power control steps |
0.1 dB for one 1 dB step 0.1 dB for ten 1 dB steps |
Pmax,c – 3 dB to Pmax,c – 28 dB |
|
6.4.3 Power control dynamic range |
0.2 dB relative code domain power accuracy |
Pmax,c – 3 dB to Pmax,c – 28 dB |
|
6.4.4 Total power dynamic range |
0.3 dB relative error over 18 dB |
Pmax,c to Pmax,c – 18 dB |
|
6.4.5 IPDL time mask |
Not critical |
Not critical |
|
6.5.1 Occupied Bandwidth |
100 kHz |
±1 MHz of the minimum requirement |
|
6.5.2.1 Spectrum emission mask |
Not critical |
Not critical |
|
6.5.2.2 ACLR/CACLR |
dB |
Measurements in the range ±3 dB of the minimum requirement at signal power = Pmax,c |
|
6.5.3 Spurious emissions |
Not critical |
Not critical |
|
6.6 Transmit intermodulation (interferer requirements) |
Not critical |
Not critical |
|
6.7.1 EVM |
2.5 % (for single code) |
Measurements in the range 12.5% to 22.5% at signal power = Pmax,c -3 dB to Pmax,c – 18 dB |
|
6.7.2 Peak code Domain error |
±1.0 dB |
Measurements in the range -30 to -36 dB at signal power = Pmax |
|
6.7.3 Time alignment error in TX diversity, MIMO, DC‑HSDPA and DB‑DC‑HSDPA transmission |
0.1 Tc |
|
|
6.7.4 Relative Code Domain Error |
±1.0 dB |
Measurements in the range -18 to -24 dB at signal power = Pmax,c |
|
Annex H.3 Transmitted code power (absolute) |
±0.9 dB |
Pmax,c – 3 dB to Pmax,c – 28 dB |
|
Annex H.3 Transmitted code power (relative) |
±0.2 dB |
Pmax,c – 3 dB to Pmax,c – 28 dB |
|
Annex H.4 Transmitted carrier power |
0.3 dB relative error over 18 dB |
Pmax,c to Pmax,c – 18 dB |