A.9A Reference measurement channel for 4C-HSDPA HS-DPCCH

25.1413GPPBase Station (BS) conformance testing (FDD)Release 17TS

Tools: ARFCN - Frequency Conversion for 5G NR/LTE/UMTS/GSM

The parameters for the 4C-HSDPA UL HS-DPCCH reference measurement channel are specified in Table A.9A.

For RRC configuration, 0 dB shall be used for HS-DPCCH power offset to DPCCH in the test. In the reference measurement channels, HS-DPCCH power offset to DPCCH in Table A.9A shall be used for the waveform during the test as per the rule in Table 2b in Section 5.1.2.5A in TS 25.214 [13].

Table A.9A: Reference measurement channels for 4C-HSDPA HS-DPCCH

Parameter								Unit
Carrier Configuration			4/4/4	4/4/2	3/3/3	3/2/1	3/3/0
DPDCH	DTCH	Information bit rate	12.2					kbps
		Physical channel	60					kbps
		Repetition rate	22					%
	DCCH	Information bit rate	2.4					kbps
		Physical channel	15					kbps
		Repetition rate	22					%
	Spreading factor		64
	Interleaving		20					Ms
	Number of DPDCHs		1
DPCCH	Dedicated pilot		6					bits/slot
	Power control		2					bits/slot
	TFCI		2					bits/slot
	Spreading factor		256
Power ratio of DPCCH/DPDCH			-2.69					dB
Amplitude ratio of DPCCH/DPDCH			0.7333
Closed loop power control			OFF
HS-DPCCH repetition			1
HS-DPCCH power offset to DPCCH			4.08	2.05	4.08	2.05	2.05	dB
HS-DPCCH timing offset to DPCCH			0					Symbol
HS-DPCCH spreading factor			128	128	128	128	256
Secondary_Cell_Enabled			3	3	2	2	2
Secondary_Cell_Active			3	1	2	1	2
Number of MIMO carriers			4	2	3	1	0
Codebook			Rel10 DC-MIMO codebook	Rel10 DC-MIMO codebook repeated	Rel10 DC-MIMO codebook	Rel10 DC-MIMO codebook repeated	Rel10 TC-MIMO codebook
			Notes 2		Notes 3	Note 3
Note 1: Carrier configuration X/Y/Z denotes X number of carriers configured, Y number of active carriers, and Z number of carriers configured as MIMO out of Y carriers. However, the configuration during the test follows Table 8.17C in TS 25.104. Note 2: If the NodeB is not capable of MIMO on all 4 active carriers, the maximum supportable number of MIMO carriers is configured. Note 3: Optional: Applies only if the NodeB is not capable of simultaneous 4 carrier operation.