5.2 PDSCH demodulation requirements
38.521-43GPPNRPart 4: PerformanceRadio transmission and receptionRelease 17TSUser Equipment (UE) conformance specification
The parameters specified in Table 5.2-1 are valid for all PDSCH tests unless otherwise stated.
Table 5.2-1: Common test parameters
Parameter |
Unit |
Value |
||
PDSCH transmission scheme |
Transmission scheme 1 |
|||
Carrier configuration |
Offset between Point A and the lowest usable subcarrier on this carrier (Note 2) |
RBs |
0 |
|
Subcarrier spacing |
kHz |
15 or 30 |
||
DL BWP configuration #1 |
Cyclic prefix |
Normal |
||
RB offset |
RBs |
0 |
||
Number of contiguous PRB |
PRBs |
Maximum transmission bandwidth configuration as specified in clause 5.3.2 of TS 38.101-1 [2] for tested channel bandwidth and subcarrier spacing |
||
Common serving cell parameters |
Physical Cell ID |
0 |
||
SSB position in burst |
First SSB in Slot #0 |
|||
SSB periodicity |
ms |
20 |
||
PDCCH configuration |
Slots for PDCCH monitoring |
Each slot |
||
Symbols with PDCCH |
Symbols |
0, 1 |
||
Number of PRBs in CORESET |
Table 5.2-2 for tested channel bandwidth and subcarrier spacing |
|||
Number of PDCCH candidates and aggregation levels |
1/AL8 |
|||
CCE-to-REG mapping type |
Non-interleaved |
|||
DCI format |
1_1 |
|||
TCI state |
TCI state #1 |
|||
PDCCH & PDCCH DMRS Precoding configuration |
Single Panel Type I, Random per slot with equal probability of each applicable i1, i2 combination, and with REG bundling granularity for number of Tx larger than 1 |
|||
Cross carrier scheduling |
Not configured |
|||
CSI-RS for tracking |
First subcarrier index in the PRB used for CSI-RS |
k0=0 for CSI-RS resource 1,2,3,4 |
||
First OFDM symbol in the PRB used for CSI-RS |
l0 = 6 for CSI-RS resource 1 and 3 l0 = 10 for CSI-RS resource 2 and 4 |
|||
Number of CSI-RS ports (X) |
1 for CSI-RS resource 1,2,3,4 |
|||
CDM Type |
‘No CDM’ for CSI-RS resource 1,2,3,4 |
|||
Density (ρ) |
3 for CSI-RS resource 1,2,3,4 |
|||
CSI-RS periodicity |
Slots |
15 kHz SCS: 20 for CSI-RS resource 1,2,3,4 30 kHz SCS: 40 for CSI-RS resource 1,2,3,4 |
||
CSI-RS offset |
Slots |
15 kHz SCS: 10 for CSI-RS resource 1 and 2 11 for CSI-RS resource 3 and 4 30 kHz SCS: 20 for CSI-RS resource 1 and 2 21 for CSI-RS resource 3 and 4 |
||
Frequency Occupation |
Start PRB 0 Number of PRB = BWP size |
|||
QCL info |
TCI state #0 |
|||
NZP CSI-RS for CSI acquisition |
First subcarrier index in the PRB used for CSI-RS |
k0 = 0 |
||
First OFDM symbol in the PRB used for CSI-RS |
l0 = 12 |
|||
Number of CSI-RS ports (X) |
Same as number of transmit antenna |
|||
CDM Type |
‘No CDM’ for 1 transmit antenna ‘FD-CDM2’ for 2 and 4 transmit antenna |
|||
Density (ρ) |
1 |
|||
CSI-RS periodicity |
Slots |
15 kHz SCS: 20 30 kHz SCS: 40 |
||
CSI-RS offset |
Slots |
0 |
||
Frequency Occupation |
Start PRB 0 Number of PRB = BWP size |
|||
QCL info |
TCI state #1 |
|||
ZP CSI-RS for CSI acquisition |
First subcarrier index in the PRB used for CSI-RS |
k0 = 4 |
||
First OFDM symbol in the PRB used for CSI-RS |
l0 = 12 |
|||
Number of CSI-RS ports (X) |
4 |
|||
CDM Type |
‘FD-CDM2’ |
|||
Density (ρ) |
1 |
|||
CSI-RS periodicity |
Slots |
15 kHz SCS: 20 30 kHz SCS: 40 |
||
CSI-RS offset |
Slots |
0 |
||
Frequency Occupation |
Start PRB 0 Number of PRB = BWP size |
|||
PDSCH DMRS configuration |
Antenna ports indexes |
{1000} for Rank 1 tests {1000-1002} for Rank 3 tests {1000-1003} for Rank 4 tests |
||
Position of the first DMRS for PDSCH mapping type A |
2 |
|||
Number of PDSCH DMRS CDM group(s) without data |
1 for Rank 1 and Rank 2 tests 2 for Rank 3 and Rank 4 tests |
|||
TCI state #0 |
Type 1 QCL information |
SSB index |
SSB #0 |
|
QCL Type |
Type C |
|||
Type 2 QCL information |
SSB index |
N/A |
||
QCL Type |
N/A |
|||
TCI state #1 |
Type 1 QCL information |
CSI-RS resource |
CSI-RS resource 1 from ‘CSI-RS for tracking’ configuration |
|
QCL Type |
Type A |
|||
Type 2 QCL information |
CSI-RS resource |
N/A |
||
QCL Type |
N/A |
|||
PT-RS configuration |
PT-RS is not configured |
|||
Maximum number of code block groups for ACK/NACK feedback |
1 |
|||
Maximum number of HARQ transmission |
4 |
|||
HARQ ACK/NACK bundling |
Multiplexed |
|||
Redundancy version coding sequence |
{0,2,3,1} |
|||
PDSCH & PDSCH DMRS Precoding configuration |
Single Panel Type I, Random precoder selection updated per slot, with equal probability of each applicable i1, i2 combination, and with PRB bundling granularity |
|||
Symbols for all unused REs |
OCNG Annex A.5 |
|||
Physical signals, channels mapping and precoding |
As specified in Annex B.4.1 |
|||
Note 1: UE assumes that the TCI state for the PDSCH is identical to the TCI state applied for the PDCCH transmission. Note 2: Point A coincides with minimum guard band as specified in Table 5.3.3-1 from TS 38.101-1 [2] for tested channel bandwidth and subcarrier spacing. |
Table 5.2-2: Number of PRBs in CORESET
SCS (kHz) |
5 MHz |
10 MHz |
15 MHz |
20 MHz |
25 MHz |
30 MHz |
40 MHz |
50 MHz |
60 MHz |
80 MHz |
100 MHz |
15 |
24 |
48 |
78 |
102 |
132 |
156 |
216 |
270 |
N/A |
N/A |
N/A |
30 |
6 |
24 |
36 |
48 |
60 |
78 |
102 |
132 |
162 |
216 |
270 |
The normative reference for this requirement is TS 38.101-4 [5] clause 5.2