3 Definition of terms, symbols and abbreviations

38.521-43GPPNRPart 4: PerformanceRadio transmission and receptionRelease 17TSUser Equipment (UE) conformance specification

3.1 Terms

For the purposes of the present document, the terms given in TR 21.905 [1] and the following apply. A term defined in the present document takes precedence over the definition of the same term, if any, in TR 21.905 [1].

aggregated channel bandwidth: The RF bandwidth in which a UE transmits and receives multiple contiguously aggregated carriers.

carrier aggregation: Aggregation of two or more component carriers in order to support wider transmission bandwidths.

carrier aggregation band: A set of one or more operating bands across which multiple carriers are aggregated with a specific set of technical requirements.

carrier aggregation bandwidth class: A class defined by the aggregated transmission bandwidth configuration and maximum number of component carriers supported by a UE.

carrier aggregation configuration: A combination of CA operating band(s) and CA bandwidth class(es) supported by a UE.

DL BWP: DL bandwidth part as defined in TS 38.213 [11].

EN-DC: E-UTRA-NR Dual Connectivity as defined in TS 37.340 [13, clause 4.1.2].

FR1: Frequency range 1 as defined in TS 38.101-3 [4] clause 5.1.

FR2: Frequency range 2 as defined in TS 38.101-3 [4] clause 5.1.

PDSCH mapping type A or B: A type of PDSCH allocation sent in the RRC message which defines the time domain allocation of PDSCH DMRS symbols. PDSCH mapping type A is slot based assignment with fixed starting OFDM symbol with variable length. PDSCH mapping type B is non-slot based assignment used for configuring min-slots.

SSB: SS/PBCH block as defined in TS 38.211 [9] clause 7.8.3.

3.2 Symbols

For the purposes of the present document, the following symbols apply:

Subcarrier spacing configuration as defined in TS 38.211 [9] clause 4.2]

The power spectral density of a white noise source with average power per RE normalized to the subcarrier spacing as defined in Section 4.4.3 for conducted requirements and Section 4.5.3 for radiated requirements

3.3 Abbreviations

For the purposes of the present document, the abbreviations given in TR 21.905 [1] and the following apply. An abbreviation defined in the present document takes precedence over the definition of the same abbreviation, if any, in TR 21.905 [1].

CA Carrier Aggregation

CC Component Carrier

CCE Control Channel Element

CORESET Control Resource Set

CP Cyclic Prefix

CSI Channel-State Information

CSI-IM CSI Interference Measurement

CSI-RS CSI Reference Signal

CW Codeword

CQI Channel Quality Indicator

CRC Cyclic Redundancy Check

CRI CSI-RS Resource Indicator

DC Dual Connectivity

DCI Downlink Control Information

DL Downlink

DMRS Demodulation Reference Signal

DPS Dynamic Point Selection

EPRE Energy Per Resource Element

EN-DC E-UTRA-NR Dual Connectivity

FR Frequency Range

FRC Fixed Reference Channel

HARQ Hybrid Automatic Repeat Request

HST High Speed Train

HST-SFN High Speed Train Single Frequency Network

LI Layer Indicator

MAC Medium Access Control

MCS Modulation and Coding Scheme

MIB Master Information Block

NR New Radio

NE-DC NR-E-UTRA Dual Connectivity

NR/5GC NR connected to 5GC NSA Non-Standalone Operation Mode

OCNG OFDMA Channel Noise Generator

OFDM Orthogonal Frequency Division Multiplexing

OFDMA Orthogonal Frequency Division Multiple Access

PBCH Physical Broadcast Channel

Pcell Primary Cell

PDCCH Physical Downlink Control Channel

PDSCH Physical Downlink Shared Channel

PMI Precoding Matrix Indicator

PRB Physical Resource Block

PRG Physical resource block group

PSS Primary Synchronization Signal

PTRS Phase Tracking Reference Signal

PUCCH Physical Uplink Control Channel

PUSCH Physical Uplink Shared Channel

QCL Quasi Co-location

RB Resource Block

RBG Resource Block Group

RE Resource Element

REG Resource Element Group

RI Rank Indicator

RRC Radio Resource Control

SA Standalone operation mode

SCS Subcarrier Spacing

SINR Signal-to-Interference-and-Noise Ratio

SNR Signal-to-Noise Ratio

SS Synchronization Signal

SSB Synchronization Signal Block

SSS Secondary Synchronization Signal

TCI Transmission Configuration Indicator

TDM Time division multiplexing

TTI Transmission Time Interval

UL Uplink

VRB Virtual Resource Block