8 Timing

36.2113GPPEvolved Universal Terrestrial Radio Access (E-UTRA)Physical channels and modulationRelease 17TS

8.1 Uplink-downlink frame timing

Transmission of the uplink radio frame number from the UE shall start seconds before the start of the corresponding downlink radio frame at the UE.

Figure 8.1-1: Uplink-downlink timing relation

Except for the cases mentioned in Table 8.1-1, Table 8.1-2 and Table 8.1-3, the range of is: .

For frame structure type 1 and for frame structure type 2 unless stated otherwise in [4]. Note that not all slots in a radio frame may be transmitted. One example hereof is TDD, where only a subset of the slots in a radio frame is transmitted.

is defined in different ranges depending on the UE configuration according to Table 8.1-1, Table 8.1-2 and Table 8.1-3. In case of subslot based transmission (Table 8.1-2 and Table 8.1-3), the UE is configured by higher layer signalling a processing timeline and an associated range of timing advance.

The quantity is derived from the higher-layer parameters TACommon, TACommonDrift, and TACommonDriftVariation if configured (see Clause 4.2.3 in TS 36.213 [4]), otherwise .

The quantity is computed by the UE based on UE position and serving satellite-ephemeris-related higher-layers parameters if configured, otherwise .

Table 8.1-1: Ranges of for a UE configured with SCG, short processing time or slot-based transmission in both DL and UL

Range of

Condition

if the UE is configured with a SCG

if the UE is configured with shortProcessingTime (see TS 36.331 [9])

if the UE is configured with dl-STTI-Length and ul-STTI-Length (see TS 36.331 [9]) set to ‘slot’ for the serving cell

Table 8.1-2: Ranges of for a UE configured with subslot-based transmission in both DL and UL (dl-STTI-Length and ul-STTI-Length, see TS 36.331 [9]. set to ‘subslot’)

Range of

proc-Timeline

nplus4set1

nplus6set1

nplus6set2

nplus8set2

NOTE 1: See TS 36.331 [9]

Table 8.1-3: Ranges of for a UE configured with subslot-based transmission in DL and slot-based transmission in UL (dl-STTI-Length and ul-STTI-Length, see TS 36.331 [9], set to ‘subslot’ and ‘slot’, respectively)

Range of

proc-Timeline

nplus4set1

nplus6set1

nplus6set2

nplus8set2

NOTE 1: See TS 36.331 [9]

In all other cases the range of is: .