A.5.3d UTRA TDD to E-UTRA TDD handover: unknown target cell
25.1233GPPRelease 17Requirements for support of radio resource management (TDD)TS
A.5.3d.1 Test Purpose and Environment
A.5.3d.1.1 3.84 Mcps TDD option
A.5.3d.1.2 1.28 Mcps TDD option
This test is to verify the requirement for UTRAN TDD to E-UTRAN TDD handover requirements specified in section 5.3b when the target E-UTRAN cell is unknown.
The test scenario comprises of 1 UTRA TDD cell and 1 E-UTRA TDD cell as given in tables A.5.3d.1.2-1, A.5.3d.1.2-2, and A.5.3d.1.2-3. No scheduled idle interval is configured in the test case.
The test consists of two successive time periods, with time durations of T1 and T2 respectively. During time duration T1, a RRC HANDOVER FROM UTRAN COMMAND message shall be sent to the UE with activation time "now" with a new active E-UTRA TDD cell, cell2. The end of the last TTI containing handover message is the beginning of T2 duration. At the start of time duration T2, the UE does not have any timing information of Cell 2.
Table A.5.3d.1.2-1: General test parameters for UTRA TDD to unknown E-UTRA TDD handover test case
Parameter |
Unit |
Value |
Comment |
|
DPCH parameters active cell |
DL Reference Measurement Channel 12.2 kbps |
As specified in TS 25.102 section A. The DPCH is located in an other timeslot than 0. |
||
PDSCH parameters |
DL Reference Measurement Channel R.0 TDD |
As specified in section A.3.1.1.2 in [24] |
||
PCFICH/PDCCH/PHICH parameters |
DL Reference Measurement Channel R.6 TDD |
As specified in section A.3.1.2.2 in [24] |
||
Initial conditions |
Active cell |
Cell 1 |
UTRA 1.28Mcps TDD cell |
|
Neighbour cell |
Cell 2 |
E-UTRA TDD cell |
||
Final conditions |
Active cell |
Cell 2 |
E-UTRA TDD cell |
|
CP length of cell 2 |
Normal |
|||
Uplink-downlink configuration |
1 |
As specified in table 4.2-2 in 3GPP TS 36.211 |
||
Special subframe configuration |
6 |
As specified in table 4.2-1 in 3GPP TS 36.211 |
||
PRACH configuration |
53 |
As specified in table 5.7.1-3 in 3GPP TS 36.211 |
||
Handover activation time |
now |
|||
Access Barring Information |
Not Sent |
No additional delays in random access procedure. |
||
T1 |
s |
≤ 5 |
During T1, cell 2 shall be powered off, and during the off time the physical layer cell identity shall be changed. |
|
T2 |
s |
1 |
Table A.5.3d.1.2-2: Cell specific test parameters for UTRA TDD to unknown E-UTRA TDD handover test case (cell 1)
Parameter |
Unit |
Cell 1 (UTRA) |
|||
Timeslot Number |
0 |
DwPTS |
|||
T1 |
T2 |
T1 |
T2 |
||
UTRA RF Channel Number* |
Channel 1 |
||||
PCCPCH_Ec/Ior |
dB |
-3 |
|||
DwPCH_Ec/Ior |
dB |
0 |
|||
OCNS_Ec/Ior |
dB |
-3 |
|||
|
dB |
4 |
4 |
4 |
4 |
|
dBm/1.28 MHz |
-80 |
|||
PCCPCH RSCP |
dBm |
-79 |
-79 |
n.a. |
|
Propagation Condition |
AWGN |
||||
* Note: In the case of multi-frequency cell, the UTRA RF Channel Number is the primary frequency’s channel number. |
Table A.5.3d.1.2-3: Cell specific test parameters for UTRA TDD to unknown E-UTRA TDD handover test case (cell 2)
Parameter |
Unit |
Cell 2 |
|
T1 |
T2 |
||
E-UTRA RF Channel Number |
2 |
||
BWchannel |
MHz |
10 |
|
OCNG Patterns defined in TS36.133 A.3.2.2.1 (OP.1 TDD) and in A.3.2.2.2 (OP.2 TDD) |
OP.2 TDD |
OP.1 TDD |
|
PBCH_RA |
dB |
0 |
0 |
PBCH_RB |
dB |
||
PSS_RB |
dB |
||
SSS_RB |
dB |
||
PCFICH_PA |
dB |
||
PHICH_PA |
dB |
||
PHICH_PB |
dB |
||
PDCCH_PA |
dB |
||
PDCCH_PB |
dB |
||
PDSCH_PA |
dB |
||
PDSCH_PB |
dB |
||
OCNG_RANote1 |
dB |
||
OCNG_RBNote1 |
dB |
||
|
dB |
-Infinity |
0 |
|
dBm/15kHz |
-98 |
|
|
dB |
-Infinity |
0 |
RSRP |
dBm/15kHz |
-Infinity |
-98 |
SCH_RP |
dBm/15kHz |
-Infinity |
-98 |
Propagation Condition |
AWGN |
||
Note 1: OCNG shall be used such that cell is fully allocated and a constant total transmitted power spectral density is achieved for all OFDM symbols. Note 2: RSRP levels have been derived from other parameters for information purposes. They are not settable parameters themselves. |
A.5.3d.1.3 7.68 Mcps TDD option
A.5.3d.2 Test Requirements
A.5.3d.2.1 3.84 Mcps TDD option
A.5.3d.2.2 1.28 Mcps TDD option
The UE shall start to transmit the PRACH to Cell 2 less than 160 ms from the beginning of time period T2.
The rate of correct handovers observed during repeated tests shall be at least 90%.