A.2 Gain outside pass band
3GPP51.026Base Station System (BSS) equipment specificationPart 4: RepeatersRelease 17TS
A.2.1 Test purpose
To determine the net gain of the repeater outside its specified pass band (or bands), when this is less than a GSM band defined in clause 4.1 of the present document. The requirements of clause 7 of the present document shall always be met, whether or not this test is also performed.
This test is not a normative requirement of the present document.
A.2.2 Test case
The repeater shall be set to maximum gain. In case of a channel selective repeater, two of the channel selective modules shall be set to the lowermost and the uppermost ARFCN within the repeaters pass band.
A continuous sinusoidal RF signal shall be fed successively at each specified frequency into the relevant input port of the repeater. The power level of the RF input signal shall be at least 5 dB below the power level which would produce, when applied within the specified pass band, maximum rated output power, as declared by the manufacturer. This is to ensure that the equipment is operating in the linear output range.
The average output power in each case shall be measured and the net gain shall be recorded.
The measurements shall apply to all antenna ports of the repeater.
Test environment: Normal
Extreme temperature
A.2.3 Conformance requirement
At each frequency specified to be measured, the gain through the repeater shall be less than the specified value.
Annex B (informative):
Change history
This annex lists all change requests approved for the present document since the first phase 2 version was approved by ETSI SMG.
|
SMG# |
SMG tdoc |
SMG8 tdoc |
VERS |
CR |
RV |
PH |
CAT |
SUBJECT |
Resulting Version |
|
S17 |
095/96 |
4.0.0 |
001 |
2 |
B |
Editorial additions and changes to comply with ETSI style |
4.1.0 |
||
|
095/96 |
4.0.0 |
002 |
2 |
D |
Addition of definition of normal and extreme conditions for testing |
4.1.0 |
|||
|
095/96 |
4.0.0 |
003 |
2 |
Definition of test method for part band repeaters |
4.1.0 |
||||
|
S18 |
257/96 |
4.1.0 |
A004 |
2 |
F |
Intermodulation attenuation |
4.2.0 |
||
|
S20 |
606/96 |
58/96 |
4.2.0 |
A005 |
2 |
D |
Correction of reference title |
4.2.1 |
|
|
s23 |
783/97 |
031/97 |
4.2.2 |
A006 |
R96 |
B |
Addition of references to the R-GSM band |
5.0.0 |
|
|
s25 |
98-0168 |
98p007 |
5.0.1 |
A007 |
R96 |
F |
Minimum offset for spurious emmisions measurements |
5.1.0 |
|
|
s26 |
98-395 |
98p051 |
5.1.0 |
A008 |
R96 |
B |
Repeater systems using frequency shift |
5.2.0 |
|
|
s26 |
98-395 |
98p056 |
5.1.0 |
A009 |
R96 |
D |
Addition of reference to ETR 027 and ETR 028 |
5.2.0 |
|
|
5.2.0 |
Version update for publication |
5.2.1 |
|||||||
|
s31b |
P-00-190 |
866/00 |
5.2.1 |
A011 |
2 |
R99 |
B |
Repeater EDGE & GSM 400 test cases |
8.0.0 |
|
8.0.1 |
Update to Version 8.0.2 for Publication |
8.0.2 |
|
Change history |
|||||||
|
Date |
TSG # |
TSG Doc. |
CR |
Rev |
Subject/Comment |
Old |
New |
|
2002-01 |
New version for Release 4 |
8.0.2 |
4.0.0 |
||||
|
2002-06 |
New version for Release 5 |
4.0.0 |
5.0.0 |
||||
|
2005-01 |
New version for Release 6 |
5.0.0 |
6.0.0 |
||||
|
2005-06 |
25 |
GP-051706 |
003 |
1 |
Addition of new frequency band (e.g. T-GSM810) to the repeater test specification |
6.0.0 |
6.1.0 |
|
2007-07 |
35 |
Version for Release 7 |
6.1.0 |
7.0.0 |
|||
|
2008-12 |
40 |
Version for Release 8 |
7.0.0 |
8.0.0 |
|||
|
2009-05 |
42 |
GP-090970 |
0006 |
1 |
Introduction of EVM requirement for EGPRS2 for Repeater |
8.0.0 |
8.1.0 |
|
2009-05 |
42 |
GP-091038 |
0007 |
1 |
Update of reference documents from ETS GSM to 3GPP |
8.0.0 |
8.1.0 |
|
2009-09 |
43 |
GP-091133 |
0010 |
Introduction of EVM requirement for EGPRS2 for Repeater |
8.1.0 |
8.2.0 |
|
|
2009-12 |
44 |
Version for Release 9 |
8.2.0 |
9.0.0 |
|||
|
2010-03 |
45 |
GP-100093 |
0016 |
EGPRS2 EVM requirements for repeater |
9.0.0 |
9.1.0 |
|
|
2011-03 |
49 |
Version for Release 10 |
9.1.0 |
10.0.0 |
|||
|
2011-09 |
51 |
GP-111375 |
0018 |
1 |
EVM for AQPSK for Repeater |
10.0.0 |
10.1.0 |
|
2011-11 |
52 |
GP-111775 |
0020 |
1 |
On EVM requirements and SCPIR_DL in the case of AQPSK Modulation |
10.1.0 |
10.2.0 |
|
2012-03 |
53 |
GP-120114 |
0022 |
Brackets removal from the SCPIR_DL value for AQPSK modulation accuracy test |
10.2.0 |
10.3.0 |
|
|
2012-03 |
53 |
GP-120406 |
0024 |
1 |
Update of Definition clause with repeater’s pass band definition |
10.2.0 |
10.3.0 |
|
2012-09 |
55 |
Version for Release 11 |
10.3.0 |
11.0.0 |
|||
|
2014-09 |
63 |
Version for Release 12 (frozen at SP-65) |
11.0.0 |
12.0.0 |
|||
|
2015-12 |
68 |
Version for Release 13 (frozen at SP-70) |
12.0.0 |
13.0.0 |
|||
|
Change history |
|||||||
|
Date |
Meeting |
TDoc |
CR |
Rev |
Cat |
Subject/Comment |
New version |
|
2017-03 |
RP-75 |
– |
– |
– |
– |
Version for Release 14 (frozen at TSG-75) |
14.0.0 |
|
2018-06 |
RP-80 |
– |
– |
– |
– |
Update to Rel-15 version (MCC) |
15.0.0 |
|
2020-07 |
RP-88e |
– |
– |
– |
– |
Upgrade to Rel-16 version without technical change |
16.0.0 |
|
2022-03 |
RP-95e |
– |
– |
– |
– |
Upgrade to Rel-17 version without technical change |
17.0.0 |