H.3 Pre-FFT minimization process
38.176-13GPPIntegrated Access and Backhaul (IAB) conformance testingNRPart 1: conducted conformance testingRelease 17TS
Sample Timing, Carrier Frequency in are varied in order to minimise the difference between and , after the amplitude ratio of and has been scaled. Best fit (minimum difference) is achieved when the RMS difference value between and is an absolute minimum.
The carrier frequency variation is the measurement result: carrier frequency error.
From the acquired samples, one value of carrier frequency error can be derived.
Note 1: The minimisation process, to derive the RF error can be supported by post-FFT operations. However the minimisation process defined in the pre-FFT domain comprises all acquired samples (i.e. it does not exclude the samples in-between the FFT widths and it does not exclude the bandwidth outside the transmission bandwidth configuration).
Note 2: The algorithm would allow to derive carrier frequency error and sample frequency error of the TX under test separately. However there are no requirements for sample frequency error. Hence the algorithm models the RF and the sample frequency commonly (not independently). It returns one error and does not distinguish between both.
After this process, the samples are called .