8.11c HS-DSCH Configurations for enhanced Cell FACH (Rel-7 or later) [Mapping CCCH/BCCH/PCCH on HS-DSCH]

34.123-33GPPPart 3: Abstract test suite (ATS)TSUser Equipment (UE) conformance specification

The purpose of this clause is to specify the general ASP sequence and to precise values only when they have something specific in the given configuration.

1. Configure HS-PDSCH physical channel

CPHY_RL_Setup_REQ(

physicalChannelIdentity,

Common_HS_PDSCH_Info)

— set up the HS-PDSCH identified by PhysicalChannelIdentity

— for the HS-PDSCH the configurable parameters are: the scrambling code, and

— set up the HS-SCCH which is associated with the HS-PDSCH without physicalChannelIdentity

— for the HS-SCCH the configurable parameters are: channelisation code set and common/dedicated H-RNTI selected by/allocated to UE

hSDSCHPhysicalLayerCategory HSDSCH_physical_layer_category,

hs_DSCH_64QAM_Support BOOLEAN,

— needed only if 64QAM[Rel-7] is supported [Cat 13 and 14]

commonOrDedicated_H_RNTI H_RNTI,

bcchSpecific_H_RNTI H_RNTI,

hs_scch_SystemInfo HS_SCCH_SystemInfo,

hs_dsch_PagingSystemInformation HS_DSCH_PagingSystemInformation,

sttd_Indicator BOOLEAN,

hs_SCCH_TxPower DL_TxPower — offset related to CPICH

hs_scch_LessInfo HS_SCCH_LessInfo_r7

— if hs-scch less operation[Rel-7] is enabled. Conditional to no DCH configured

in UL as well.

mimo_Parameters MIMO_Parameters

— optionally present when MIMO is configured.

— mimo and HS-SCCH cannot be simultaneously configured.

6. Configure HS-DSCH transport channels

CPHY_TrCH_Config_REQ(

physicalChannelIdentity,

ehs_DSCH_CommonFlows)

— set up the HS-DSCH transport channel MAC-ehs common lows identified by mac_ehs_QueueId

in the EHS_DSCH_Flows.

— for each MAC-ehsQueue the configurable parameters are: mac_ehs_QueueId ;reorderingReleaseTimer T1; mac_ehsWindowSize;

the number of harq processare is configurable

7. Configure MAC-hs/MAC-ehs entity for HS-DSCH

CMAC_MAChs_MACehs_TFRCconfigure_REQ(

explicit TRFC config mode with:

hs_pdsch_CodeIndex,

hs_scch_LessTFI,

hs_scch_LessSecondCodeApplicability,

hs_PDSCH_TxPower)

CMAC_Config_REQ(

physicalChannelIdentity,

uE_Info,

ehs_DSCH_CommonFlows)

— the ehs_DSCH_CommonFlows shall be same as that used in CPHY_TrCH_Config_REQ.

— set up ehs-DSCH flows identified by mac_ehs_QueueId in the hsDSCHMacdFlows.

— set up the mapping between each ehs_DSCH_CommonFlows and the logical channels which are mapped on the flow.

— MAC_ehs entity is created per cell. In case of Intra Node B Handover this entity at the UE will not be reset whereas in the TTCN it will be released in the first cell and setup in the second cell.