16.3 Short message service cell broadcast
34.123-13GPPPart 1: Protocol conformance specificationRelease 15TSUser Equipment (UE) conformance specification
16.3.1 Definition
16.3.2 Conformance requirements
In idle mode, the UE has the ability to ignore repeated broadcasts of CBS messages already received (the message has not changed since it was last broadcast i.e. sequence number has not changed within the message’s indicated geographical area);
A UE supporting Cell Broadcast Service (CBS) shall be capable to receive BMC messages in the Idle mode.
References
– 3GPP TS 23.041 clause 8.
– 3GPP TS 25.324 clause 11.
16.3.3 Test purpose
This test verifies that an UE supporting SMS-CB is able to receive SMS-CB messages and is able to ignore repeated broadcasts of CBS messages.
16.3.4 Method of test
Initial conditions
– System Simulator:
– 1 cell, default parameters;
– the SS provides a BCCH/CCCH to support the UE in idle mode;
– periodic location updating is disabled.
– User Equipment:
– the UE shall be in the idle updated state.
Related ICS/IXIT Statements
Support for short message transmission cell broadcast.
Test procedure
Three Cell Broadcast (CB) messages are sent by the SS on the CTCH with message codes 0,1,1 in serial number fields respectively.
NOTE: If the UE fails the test because of a failure to receive the message due to collision of CTCH and paging occasion, then the operator may re-run the test.
Expected sequence
Since the SMS-CB messages are sent continuously, a table is not applicable in this test.
Specific Message Contents:
Use the default parameter values for the system information block 1 with the same type specified in clause 6.1.0b of TS 34.108, with the following exceptions:
|
– CN domain identity |
|
PS |
|
– CHOICE CN Type |
|
GSM-MAP |
|
– CN domain specific NAS system information |
|
|
|
– GSM-MAP NAS system information |
|
05 00H |
|
– CN domain specific DRX cycle length coefficient |
|
9 |
|
– CN domain identity |
|
CS |
|
– CHOICE CN Type |
|
GSM-MAP |
|
– CN domain specific NAS system information |
|
|
|
– GSM-MAP NAS system information |
|
1E 01H |
|
– CN domain specific DRX cycle length coefficient |
|
9 |
Use the default parameter values for the system information block 5 with the same type specified in clause 6.1.0b of TS 34.108, with the following exceptions:
|
– FACH/PCH information |
|
|
– TFS |
(PCH) |
|
– CHOICE Transport channel type |
Common transport channels |
|
– Dynamic Transport format information |
|
|
– RLC Size |
240 |
|
– Number of TB and TTI List |
|
|
– Number of Transport blocks |
0 |
|
– Number of Transport blocks |
1 |
|
– CHOICE Logical channel List |
ALL |
|
– Semi-static Transport Format information |
|
|
– Transmission time interval |
10 ms |
|
– Type of channel coding |
Convolutional |
|
– Coding Rate |
1/2 |
|
– Rate matching attribute |
230 |
|
– CRC size |
16 bit |
|
– Transport channel Identity |
12 (for PCH) |
|
– CTCH indicator |
FALSE |
|
– TFS |
(FACH) |
|
– CHOICE Transport channel type |
Common transport channels |
|
– Dynamic Transport format information |
|
|
– RLC Size |
168 |
|
– Number of TB and TTI List |
|
|
– Number of Transport blocks |
0 |
|
– Number of Transport blocks |
1 |
|
– Number of Transport blocks |
2 |
|
– CHOICE Logical channel List |
ALL |
|
– Semi-static Transport Format information |
|
|
– Transmission time interval |
10 ms |
|
– Type of channel coding |
Convolutional |
|
– Coding Rate |
1/2 |
|
– Rate matching attribute |
220 |
|
– CRC size |
16 bit |
|
– Transport channel Identity |
13 (for FACH) |
|
– CTCH indicator |
TRUE |
|
– TFS |
(FACH) |
|
– CHOICE Transport channel type |
Common transport channels |
|
– Dynamic Transport format information |
|
|
– RLC Size |
360 |
|
– Number of TB and TTI List |
|
|
– Number of Transport blocks |
0 |
|
– Number of Transport blocks |
1 |
|
– CHOICE Logical channel List |
ALL |
|
– Semi-static Transport Format information |
|
|
– Transmission time interval |
10 ms |
|
– Type of channel coding |
Turbo |
|
– Rate matching attribute |
130 |
|
– CRC size |
16bit |
|
– Transport channel Identity |
14 (for FACH) |
|
– CTCH indicator |
FALSE |
|
– PICH info |
|
|
– CHOICE mode |
FDD |
|
– Channelisation code |
2 |
|
– Number of PI per frame |
18 |
|
– STTD indicator |
FALSE |
|
– CBS DRX Level 1 information |
|
|
– Period of CTCH allocation (N) |
2 |
|
– CBS frame offset (K) |
0 |
Cell broadcast test message content
|
Information element |
Comment Value |
|
Message Type |
CBS Message "1"B (see 3GPP TS 25.324, clause 11.1) |
|
Message ID |
|
|
Serial Number |
|
|
– Geographical scope |
"01"B |
|
– Message code |
see test procedure "0000000000"B or "0000000001"B |
|
– Update number |
as applicable |
|
Data Coding Scheme |
Default alphabet, English "00000001"B |
|
CB Data |
max 1246 octets |
16.3.5 Test requirements
In consequence of test the UE shall ignore third message and store two messages.