13 Adjacent Channel Rejection Ratio (ACRR)
25.1063GPPRelease 17TSUTRA repeater radio transmission and reception
13.1 Definitions and applicability
Adjacent Channel Rejection Ratio (ACRR) is the ratio of the RRC weighted gain per carrier of the repeater in the pass band to the RRC weighted gain of the repeater on an adjacent channel.
The requirement shall apply to the Uplink and Downlink of Repeater where the donor link is maintained via antennas (over the air Repeater).
13.2 Minimum Requirements
In normal conditions the ACRR shall be higher than the value specified in the Table 13.1.
Table 13.1: Repeater ACRR
|
Repeater maximum output power as in 9.1.1 |
Channel offset from the centre frequency of the first or last 5 MHz channel within the pass band. |
ACRR limit |
|
P 31 dBm |
5 MHz |
33dB |
|
P 31 dBm |
10 MHz |
33dB |
|
P < 31 dBm |
5 MHz |
20dB |
|
P < 31 dBm |
10 MHz |
20dB |
Annex A (informative):
Change History
|
TSG |
Doc |
CR |
R |
Title |
Cat |
Curr |
New |
Work Item |
|
RP-31 |
Rel-7 version created; based on v6.4.0 |
7.0.0 |
||||||
|
RP-31 |
RP-060100 |
0042 |
2 |
Introduction of operating band III to IX requirements in 25.106 |
B |
6.3.0 |
7.0.0 |
TEI7 |
|
RP-31 |
RP-060110 |
0043 |
Correction of spurious emissions for coexistence with GSM900 in same geographic area |
F |
6.3.0 |
7.0.0 |
RInImp-UMTS900 |
|
|
RP-33 |
RP-060520 |
0046 |
1 |
Clean up of Spurious emissions |
A |
7.0.0 |
7.1.0 |
TEI5 |
|
RP-33 |
RP-060521 |
0049 |
1 |
New UTRA Repeater up-link spurious emissions limits for co-existence/co-location with TDD |
A |
7.0.0 |
7.1.0 |
TEI5 |
|
RP-34 |
RP-060811 |
0052 |
1 |
Corrections to input intermodulation |
A |
7.1.0 |
7.2.0 |
TEI5 |
|
RP-36 |
RP-070370 |
0056 |
Category B spurious emission limits for UTRA Repeater |
A |
7.2.0 |
7.3.0 |
TEI4 |
|
|
RP-36 |
RP-070373 |
0057 |
Introduction of operating band X into the repeater specification |
B |
7.2.0 |
7.3.0 |
TEI7 |
|
|
RP-39 |
RP-080126 |
0058 |
Introduction of UMTS1500 requirements |
B |
7.3.0 |
8.0.0 |
RInImp8-UMTS1500 |
|
|
Minor correction to CR implementation |
8.0.0 |
8.0.1 |
||||||
|
Update of history table |
8.0.1 |
8.0.2 |
||||||
|
RP-42 |
RP-080943 |
60 |
1 |
Introduction of operating band unwanted emission |
F |
8.0.2 |
8.1.0 |
TEI8 |
|
RP-45 |
RP-080819 |
61 |
Introduction of band XII, XIII, XIV |
F |
8.1.0 |
8.2.0 |
TEI8 |
|
|
RP-45 |
RP-080819 |
62 |
CR to limit the scope to FDD only to 25.106 |
F |
8.1.0 |
8.2.0 |
TEI8 |
|
|
RP-46 |
RP-091277 |
063 |
|
Corrections on additional spectrum emission limits for Bands XII, XIII, XIV |
F |
8.2.0 |
TEI8 |
|
|
Automatic upgrade from previous Release |
8.3.0 |
9.0.0 |
TEI9 |
|||||
|
RP-49 |
RP-100925 |
064 |
|
Introduction of operating band XIX, XX and XXI and correction of band XI |
F |
9.0.0 |
9.1.0 |
TEI9 |
|
RP-49 |
RP-100913 |
067 |
1 |
RCDE for 64QAM modulated codes for FDD Repeater |
A |
9.0.0 |
9.1.0 |
TEI7 |
|
RP-50 |
RP-101336 |
072 |
Protection of cdma and E-UTRA bands |
A |
9.1.0 |
9.2.0 |
TEI8 |
|
|
RP-50 |
RP-101337 |
074 |
Removal of brackets |
A |
9.1.0 |
9.2.0 |
TEI8 |
|
|
RP-50 |
RP-101347 |
068 |
Remove test settings for unwanted emissions from core spec |
F |
9.1.0 |
9.2.0 |
TEI9 |
|
|
RP-50 |
RP-101347 |
069 |
Corrections to the symbols and abbreviations clause related to DTT requirement |
F |
9.1.0 |
9.2.0 |
TEI9 |
|
|
RP-50 |
RP-101347 |
070 |
Co-existence with services in adjacent frequency bands |
F |
9.1.0 |
9.2.0 |
TEI9 |
|
|
RP-51 |
RP-110352 |
0075 |
– |
Inclusion of E-UTRA TDD text to co-location on 25.106 |
F |
9.2.0 |
10.0.0 |
TEI10 |
|
RP-55 |
RP-120303 |
078 |
1 |
Correction on the table of Regional requirements |
F |
10.0.0 |
10.1.0 |
TEI10 |
|
RP-55 |
RP-120303 |
079 |
1 |
Introduction of operating frequency band XXII |
B |
10.0.0 |
10.1.0 |
TEI10 |
|
RP-55 |
RP-120303 |
080 |
1 |
Introduction of operating frequency band XXV and protection limits towards E-UTRA Band 23 |
B |
10.0.0 |
10.1.0 |
TEI10 |
|
RP-56 |
RP-120783 |
082 |
2 |
Update of the Definition clause with repeaters operating band definition and introduction of minor editorial changes for better alignment with BS core specification |
F |
10.1.0 |
10.2.0 |
TEI10 |
|
RP-56 |
RP-120765 |
085 |
|
Additional spurious emissions requirements for PHS |
A |
10.1.0 |
10.2.0 |
TEI8 |
|
RP-57 |
RP-121313 |
088 |
2 |
Introduction of missing Spurious Emission limits and Input Intermodulation requirements towards E-UTRA FDD Band 24 |
F |
10.2.0 |
10.3.0 |
TEI10 |
|
SP-57 |
– |
– |
– |
Update to Rel-11 version (MCC) |
– |
10.3.0 |
11.0.0 |
– |
|
RP-58 |
RP-121867 |
095 |
Introduction of Spurious Emission limits and Input Intermodulation requirements towards missing UTRA and E-UTRA TDD frequency bands |
A |
11.0.0 |
11.1.0 |
TEI10 |
|
|
RP-58 |
RP-121867 |
096 |
Introduction of a Note on non deployment of operating bands with overlapping frequency ranges for the tables for Input Intermodulation requirements |
A |
11.0.0 |
11.1.0 |
TEI10 |
|
|
RP-58 |
RP-121858 |
097 |
Modifications of frequency ranges for E-UTRA Band 6, 18, 19 in the Tables for Spurious Emission limits and Input Intermodulation requirements |
A |
11.0.0 |
11.1.0 |
RInImp9-UMTSLTE800 |
|
|
RP-58 |
RP-121867 |
100 |
The special cases for protection of UTRA Band III and Band X in co-existence and co-location with UTRA Repeaters |
A |
11.0.0 |
11.1.0 |
TEI10 |
|
|
SP-65 |
– |
– |
– |
Update to Rel-12 version (MCC) |
– |
11.1.0 |
12.0.0 |
|
|
RP-66 |
RP-142154 |
103 |
|
Update with regard to operating bands of TS25.106 |
F |
12.0.0 |
12.1.0 |
LTE_UTRA_SDL_BandL-Core, LTE450_Brazil-Core, LTE_WCS_band-Core, LTE_DL_FDD700-Core, LTE_APAC700-Core, LTE_e850_LB-Core,E850_UB-Core |
|
SP-70 |
– |
– |
– |
Update to Rel-13 version (MCC) |
– |
12.1.0 |
13.0.0 |
|
|
RP-75 |
– |
– |
– |
Update to Rel-14 version (MCC) |
– |
13.0.0 |
14.0.0 |
|
Change history |
|||||||
|
Date |
Meeting |
TDoc |
CR |
Rev |
Cat |
Subject/Comment |
New version |
|
2018-06 |
SA#80 |
– |
– |
– |
– |
Update to Rel-15 version (MCC) |
15.0.0 |
|
2020-06 |
SA#88 |
– |
– |
– |
– |
Update to Rel-16 version (MCC) |
16.0.0 |
|
2022-03 |
SA#95 |
Update to Rel-17 version (MCC) |
17.0.0 |
||||