A.8A Reference measurement channel for HS-DPCCH for 4C-HSDPA
25.1043GPPBase Station (BS) radio transmission and reception (FDD)Release 17TS
The parameters for the UL 4C-HSDPA HS-DPCCH reference measurement channels are specified in Table A.8A. For RRC configuration, 0 dB shall be used for HS-DPCCH power offset to DPCCH in the test. In the reference measurement channels, HS-DPCCH power offset to DPCCH in Table A.8A shall be used for the waveform during the test as per the rule in Table 2b in Section 5.1.2.5A in TS 25.214 [12].
Table A.8A: Reference measurement channels for 4C-HSDPA HS-DPCCH
Parameter |
Unit |
|||||||
Test Configuration |
4/4/4 |
4/4/2 |
3/3/3 |
3/2/1 |
3/3/0 |
|||
DPDCH |
DTCH |
Information bit rate |
12.2 |
kbps |
||||
Physical channel |
60 |
kbps |
||||||
Repetition rate |
22 |
% |
||||||
DCCH |
Information bit rate |
2.4 |
kbps |
|||||
Physical channel |
15 |
kbps |
||||||
Repetition rate |
22 |
% |
||||||
Spreading factor |
64 |
|||||||
Interleaving |
20 |
Ms |
||||||
Number of DPDCHs |
1 |
|||||||
DPCCH |
Dedicated pilot |
6 |
bits/slot |
|||||
Power control |
2 |
bits/slot |
||||||
TFCI |
2 |
bits/slot |
||||||
Spreading factor |
256 |
|||||||
Power ratio of DPCCH/DPDCH |
-2.69 |
dB |
||||||
Amplitude ratio of DPCCH/DPDCH |
0.7333 |
|||||||
Closed loop power control |
OFF |
|||||||
HS-DPCCH repetition |
1 |
|||||||
HS-DPCCH power offset to DPCCH |
4.08 |
2.05 |
4.08 |
2.05 |
2.05 |
dB |
||
HS-DPCCH timing offset to DPCCH |
0 |
Symbol |
||||||
HS-DPCCH spreading factor |
128 |
128 |
128 |
128 |
256 |
|||
Secondary_Cell_Enabled |
3 |
3 |
2 |
2 |
2 |
|||
Secondary_Cell_Active |
3 |
1 |
2 |
1 |
2 |
|||
Number of MIMO carriers |
4 |
2 |
3 |
1 |
0 |
|||
Codebook |
Rel10 DC-MIMO codebook |
Rel10 DC-MIMO codebook repeated |
Rel10 DC-MIMO codebook |
Rel10 DC-MIMO codebook repeated |
Rel10 TC-MIMO codebook |
|||
Notes 2 |
Notes 3 |
Note 3 |
||||||
Note 1: Test configuration X/Y/Z denotes X number of carriers configured, Y number of active carriers, and Z number of carriers configured as MIMO out of Y carriers. However, the configuration during the test follows Table 8.17C. Note 2: If the NodeB is not capable of MIMO on all 4 active carriers, the maximum supportable number of MIMO carriers is configured. Note 3: Optional: Applies only if the NodeB is not capable of simultaneous 4 carrier operation. |